Final mounting

Danger of short-circuits and damage to the unit. Humidity will penetrate if electronics cover is not fitted correctly.

  1. Press electronics cover firmly onto housing such that it is sealed and flush all the way around. When doing so, do not press setting buttons.

11

Setting button for start delay

12

Setting button for overrun time

  1. Push the electronic cover on the housing cut-outs I, II and III onto the 3 locking tabs, until the tabs engage. In addition, press the electronics cover firmly on to the housing at the points indicated by the word "PRESS".
  3. For device versions F, KF, H, KH, B and KB, insert the supplied sensor in the correct position (→ arrows X), into the connector socket.

H and KH: Do not touch/push on the membrane on the flat side of the sensor wall, otherwise it will be damaged.

  1. Attach housing cover.
  2. Use the setting keys to set the start delay and/or overrun time → Start delay and overrun time.

  3. 6

    Cover

    7

    Designer cover

  4. Fit designer cover.